Most helpful customer reviews
9 of 10 people found the following review helpful.
The seller is 5 STAR! My concern is with the product.
By David P. Harm, Sr.
I emailed the seller, who forwarded the message to their supplier, concerning the fact that the roller wouldn't roll (unless nearly flat to the surface). My assessment as a former machine shop quality inspector was that the bushing at the 90 degree bend was being angled by the deformed metal of that bend. The misalignment of that bushing with the outer bushing caused the roller to bind. (Ovalization of the bushing may have contributed, but the roller would roll if only about halfway onto the bushing.) I later over-bent the 90 degree bend to be slightly acute, and then brought the end of the roller shaft back to nearly 90 deg. The shaft now has a slight wave in it. Now the roller will roll when the handle is 30 to 45 degrees or etc. from the surface. I do hope that the manufacturer has rectified this issue.
David P. Harm, Sr.
4 of 4 people found the following review helpful.
Good Fiberglass Roller
By C Hanson
This tool helped roll out the air in the fiberglass mat when wetting it down with resin. Worked good and cleaned up nice as long as you got it in the cleaner before the resin started hardening.
2 of 2 people found the following review helpful. See all 26 customer reviews...
By Nikon Guy
Perfect for those larger lay ups. Does a good job at getting the air bubbles out, far better than sitting there stabbing them with a utility knife, and a lot faster.